Dynamic Engineering PMC2PCI Spécifications télécharger pdf (Page 27)

HARDWARE INSTALLATION

PP 41x/03x 2-5

2.4.8 Switch (SW)

A pushbutton switch is recessed behind the front panel, and provides a means of generating a

reset or NMI to the board.

The reset or NMI function is selected by the setting of the Front Panel Switch Function switch

shown in Figure 2-3.

Figure 2-3 Front Panel Switch Function

Selecting the Reset position setting will cause the board to be reset when the front panel switch is

operated. If the board is in the System Controller Slot, it will also assert RST# on the CompactPCI

backplane and hence will reset the other boards in the chassis. If the board is operating as a

Peripheral or Satellite, it will respond to front panel resets but will not reset the other boards in the

chassis.

Selecting the NMI position setting configures the switch to generate NMI when operated. No reset

is generated in this case.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 127 128

Pas de commentaire

Dynamic Engineering PMC2PCI Spécifications Page 27